29
the connection of each part is OK, not allow any loosening, should stop
and check if there is any anomalous.
z
Not allow to do big load work after cold start immediately, especially
new machine or after overhauled.
z
Check the engine and gearbox oil, replenish immediately when oil level
is low.
z
Cooling the engine with watering is forbidden.
z
Avoid toppling when tilling. Pay attention to the engine angle when
working, it must not be more than 20 degrees.
Note:
Should keep the machine on horizontal position, not let the handlebar
on ground, otherwise, after oil flowing into combustion chamber, it will be
very difficult to start.
z
It's forbidden to walk on a sandy place, pebble piles after assembling
with blades.
z
Remove the clay, weed, oil stain etc. on the tiller after use.
z
Clean the spongy body which inside of filter frequently, and change the
engine oil frequently.
4. High altitude operation
At high altitude, the standard carburetor air–fuel mixture will be
excessively rich. Performance and fuel consumption will increase.
High altitude performance can be improved by installing a smaller diameter
main fuel jet in the carburetor and readjusting the pilot screw. If you always
operate the tiller at altitude higher than 1,830m (6,000 feet) above sea level
ask your authorized dealer to perform these carburetor modifications.
Even with suitable carburetor jetting, engine horsepower will decrease
Summary of Contents for RG3.6-100Q-Z-II
Page 48: ...93004 U080410 0000...
