3. TROUBLESHOOTING
34
Wash the carburetor in the clean place, First, clean the outside surface, and wash the inside
the parts with special carburetor detergent or industrial gasoline. Exception for washing
impurities, also wash the gasoline colloid on the part surface. Blow the washed parts clean
with compression air, and don’t use cloth and paper against recontamination. Don’t use the
steel wire and other hard material to open the blocked hole to prevent carburetor performance
from changing holes diameter. Use the gasoline and compression air to clean it.
FLOAT PIN
FLOAT VALVE
PILOT SCREW
CARBURETOR
(Clean with compressed
air before installation)
FLOAT
(After installing, check for
operation by lightly
pushing with a finger)
GASKET
FLOAT CHAMBER
(Install so that the drain bolt
facing to choke valve.)
DRAIN BOLT
Set Bolt
(Tighten the bolt securely and
check for gasoline leakage).
PILOT JET
MAIN NOZZLE
MAIN JET
IDLE SPEED SCREW
WASHER
