45
General Set (time, date, sea pressure)
To navigate the menu follow the instructions in the picture on the left.
UTC:
Main time zone (0:00 Greenwich)
UTC2:
Secondary time zone
Attention: in the Logbook only the UTC is registered, not the UTC2
TIME:
It changes the time hh:mm:ss (seconds can be only reset)
FORMAT:
It sets the time format (24hr o 12hr)
DATE:
It sets the date
UNITS:
it sets the metric or imperial unit of measure .
PSEA:
Set the reference mbar value above the sea level according to the
current position.
The best way to get the reference mbar is to browse:
https://www.sailwx.info/wxobs/pressure.phtml (or to refer to the national air force) and set the measured
value of the weather station closest to your location
PC Mode (connect the iX3M to a PC/Mac)
To connect the iX3M to the PC install the DiveLogger (available free of charge in the
web site www.ratio-computers.com/support)
1. Open the Divelogger on a PC or MAC and select the iX3M model
2.Activate the PC mode on the iX3M
3. Connect the USB cable to the iX3M and to the PC or Mac
4. Press “Settings” in the Divelogger and select the COM port
(usually the PC gives COM the higher value)
5. Press “Connect”
In case of connectivity problems, see the video tutorial available in the “Support”
section of the web site www.ratio-computers.com
gENERAl SET
UTC:
UTC2:
TIME:
FORMAT:
DATE:
UNITS:
PSEA:
b
A
C
D
ExIT
NExT
ENTRY
+
_
1:00
1:00
16:22:00
24
02.07.15
m/°C
1012 mb
PC MODE
S/N : 000000
CABLE: READY
BT: READY
A
ExIT
