pg. 2
2100-CPV Series Emergency Call Station
Parts Listing Provided by Rath:
1. Strobe
2. Rath SmartPhone
3. Nema electrical box mounted inside call station
4.
120 AC to DC Transformer
Call Station Installation:
1. Remove 12 security screws from the sides of unit.
2. Remove top cap from unit.
3. Pull front assembly away from back unit.
4. Disconnect the gray Wago connector (see diagram on next page)
5. If wall mount, mount to wall.
6. If pole mount, attach unit to pole using a secure mounting fastener.
7. Connect the electrical conduit of the 110ac volt supply to the call station and run necessary wires.
8. Connect the 110ac wiring to the call station power cable (see diagram on next page)
9. Turn on the 110ac power to the call station
C O M M U N I C A T I O N S
E M E R G E N C Y
866-850-8854 www.rathsecurity.com
5.
Voltage Regulator
6.
Torx Bit
Rath recommends that the call station be mounted so that the push button is less than 48 inches above
the ground to comply with the Americans with Disabilities (ADA) requirements. For ease of installation,
two people should perform the install.