EN
13
If the blade is no more able to cut (even after repeating
the sharpening operation several times), it is necessary
to replace it. In order to carry out this operation, use
butterfly wrench “1” and drift “3” locking the blade
(shown in picture 9).
In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
I talian Legislative Decree 81/ 08;
2)
Remove the safety back fixed protection “A” (see
picture 10), by unscrewing the two slot ted
screws “C” by means of a screwdriver (not
supplied by the manufact urer) as shown in
picture 11.
Remove the safety front mobile protection “B”
(see picture 10) by unscrewing pin “D” and by
extracting the two washers “E” as shown in
picture 11.
3)
I nsert drift “3” (see picture 12) into hole “F” in
order to lock the blade (the hole in the blade
must correspond to the hole in the structure).
4)
Use butterfly wrench “1” in order to unscrew
nut “G” (see picture 12) and remove blade “H”
(see picture 13).
5)
Replace the worn blade with the new one “2”,
being careful to center the blade on the shaft,
in t he correct posit ion, and rem em ber t o
assemble it with the side with the writing Rasor
positioned towards the external side of the
battery scissors.
6)
Assemble all the components again and carry
out some cutting and sharpening tests.
11
3
16. BLADE REPLACEMENT
1
2
3
9
C
D
12
B
A
10
E
F
1
G
H
13
