10
EN
A
11. USE
3
To use the battery scissors manually, proceed as follows:
1) Release the battery (if it is charged) from the
charger as described at paragraph 13;
2) Connect the battery to the motor and fix it
following the slots on the battery;
3) Lay the material to be cut on a table;
4) Put the material on the cutting foot (see picture
3);
5) Let the switch slide forward in order to start the
scissors;
6) Push the battery scissors in the desired direction,
being careful to keep the material in front of them
as stretched as possible and preventing it from
curling in the front part of the scissors.
NOTE
The thrust on the battery scissors must be as uniform as
possible. To carry out linear cuts with precision (and to
follow predetermined paths), we also recommend using
the arrow point (see point “A” in picture 4).
4
12. SPEED REGULATION
5
The scissors ZERO702 have a regulator for 6 speed levels
(see picture 5). It is possible to change the speed also
when the scissors are working. The blade speed can go
from 600 rpm (Pos. “1”) to 1000 rpm.
The “standard” position is position “2” for most materials.
It is advisable to use low speed levels for hard, gummy,
plastic or adhesive materials. High speed levels are instead
suggested for natural fibers and simple fabrics or when
a raised speed is needed.
WARNING
Using the battery scissors ZERO702 with high blade speed accelerates the wear of
the moving parts such as blade, counterblade and gear pair.
The high blade speed determines also a faster loss of battery charge.
