EN
9
10. RESIDUAL RISKS
11. INSTALLATION AND USE
Even though the cutting unit is safe, operators must pay attention to preserve their and
other people’s safety.
At the end of the working operations, the motor could be very hot.
The cutting blade can work even if the protective device is disassembled.
To install and use the cutting unit manually, proceed as follows:
1) Fix the cutting unit on level squares or angles by means of four 5MA screws, by inserting
them in the four holes located in the motor lower cover (see pictures 4 and 5).
NOTE
The cutting unit can be installed in any position/angle: vertically, laterally and it can be turned
upside down. It is not necessary that the aluminium base touch the machine table.
2) Lay the material to be cut;
3) Plug the cutting unit into the electrical outlet (see picture 6);
4) Put the material on the cutting foot (see picture 7);
5) Adjust the front mobile protection according to the thickness of the material to be
cut (see picture 7);
6) Enable the switch; once it has been enabled, it lights up with a green light (see picture 8).
NOTE
Cutting unit SW12SSX can work in a fixed position (the material moves) or it can move
forward while the material is kept in the same position. Make sure the material to be cut is
properly stretched, preventing it from curling.
WARNING
Never use the two bolts which fix the motor to the cutting part to fasten cutting unit SW12SSX.
This operation may cause the motor shaft to break. In this case, warranty is not valid.
7
8
4
5
6
