Rasonic RDW-J6P, Operation Manual

Page: 34 / 38

– 33 –
座
檯
式
洗
碗
碟
機
Table
Top
Dishwasher
6. Connect the power supply, the water tank indicator on the top starts to flash. Fill the tank with
the measuring cup supplied until the indicator stops flashing representing the tank is fully filled.
(
ATTENTION!
Under any condition, do not disassembly the round filter from the water tank
opening.)
*** If the water tank cannot be fully filled within 2 minutes, the appliance will return to standby
mode with all the indicators on the display and the water tank indicator will switch off. Press the
【
POWER
】
once to change back to operation mode. Once resumed, the refill indicator on the
display and the water tank indicator will NOT be switched on if the water tank is fully filled.
*** Reserve enough space above for water filling if manual water injection is selected.
*** If fixed water supply installation is used, ignore this procedure. If selected fixed installation, water
will be injected automatically once cleaning mode selected. Refer to Chapter 3. Installation Method
if fix water supply installation is needed.
7. Press the
【
POWER
】
key. Select the desired washing mode and press
【
START/PAUSE
】
key to start
the operation. Once confirmed, if change washing function is needed, long press 【 POWER 】 t o
shut down. Then start and select desired washing function.
8. User is suggested to rinse the filters under running water after use immediately until most of the
soils are removed to prevent bacterial growth. (If the soils are hard-to-remove, use a soft brush
to clean. Do not use wire brush or scouring pad, otherwise, they may damage the filters.)
9. The appliance equipped with the ventilation function. It will be automatically activated when
washing program finished, and ventilation indicator “ ” will light on accordingly. To cancel,
long press the
【 POWER 】 key directly and unplug the power plug.