Rasonic RDW-J6P, Operation Manual

Page: 25 / 38

– 24 –
座
檯
式
洗
碗
碟
機
Table
Top
Dishwasher
3. Installation Method
Note! Please install the appliance carefully according to the instructions. If it is not installed, tested or
inspected in accordance with the manual, our company will refuse liability and repairing cost for the
damage caused.
The using of Water source of the appliance can be came from either manual water filling or fix water
inlet connecting: for manual water filling, user can pour sufficient water into water tank directly; if fix
water inlet connection method is used, pay attention to the following:
• Once installation completed, trail test should be carried out and use it until it is properly checked.
• Do not use old water hose to avoid water leakage.
• The appliance has been tested during production. It is normal phenomenon if water residue is
found inside the packaging materials.
• The rated inlet pressure of the appliance ranges from 0.1 MPa to 1 MPa. Make sure that the water
pressure at the installation location is within the applicable range. When the water pressure is low,
the operation time may be extended. If necessary, check with professionals before installation.
If fix water inlet installation is chosen, Users can follow the steps below to install:
1. Turn off the water source
It must be confirmed that the water inlet system has been completely closed.
2. Installing the connection (three-way) ball valve
Water Inlet
Metal Hose
Rubber
Ring
Hot Water
Angle Valve
Cold Water
Angle Valve
PE Tube (Length: 1.5m (approx.))
(Three-way) Ball Valve
Step 1: As shown above, connect the connection ball valve to the cold water angle valve.