INSTALLATION
PLUMBING
WARNING: Hazard of Flooding
Toilets mounted at or below the waterline must
have a vented loop installed in the discharge
line. The top of the vented loop must be a
minimum of 4" (10cm) above the waterline at
the boats greatest angle of heel (see vented loop
manufacturer’s instructions).
Sea Water Models must also have a vented loop
installed between the intake pump and the
toilet bowl.
Double clamp all below waterline connections.
•
Hazard of potable water contamination.
Vacuum breaker must be installed with
installations using potable water.
IMPORTANT:
•
Fittings and 90° bends should be kept to a
minimum.
•
In-Line Strainer must be installed before
the Remote Intake pump. Failure to do so
may void warranty.
•
Discharging untreated sewage is restricted
in all U. S. waters within the three-mile
limit. If boating outside of U.S. Boundaries
check with local authorities for their rules
and regulations.
•
Thru-hull fittings and seacocks must be
installed where they are easily accessible.
•
Use only quality reinforced hoses.
•
Secure all hoses properly.
Discharge Lines
1. Connect quality 1 1/2" (38mm) sanitation
hose to discharge fitting on toilet.
2. Run hose to appropriate device (i.e.: treatment
system, holding tank, etc.).
Pressurized Freshwater Model
Installed Above Waterline
Crown head II
Holding Tank
Holding Tank
Crown head II
Vacuum
Breaker
Waterline
Crown head II
Waterline
Water
Solenoid
Valve
Shut off
Valve
Remote Intake Pump Model
Mounted Above Waterline
Remote
Intake
Pump
In-Line
Strainer
Lectra/San
Discharge
Vented
Loop
Waterline
Intake
Seacock
Y Valve
Discharge
Seacock
Lectra/San
Waterline
Waterline
Intake
Seacock
Intake
Vented
Loop
Discharge
Seacock
Discharge
Vented
Loop
Remote Intake
Pump
In-Line
Strainer
Remote Intake Pump Model
Mounted Below Waterline
Waterline
10
