Loading Hard Disk
4
Caution:
Hard disk that can be mounted is 2.5" IDE hard disk for laptops.
No jumper setting is required for 2.5" hard disk.
Four pins positioned on the left side of the rear are used for jumper setting. Please make certain that all jumpers
are removed from here. (Hard disk with no jumper here is a master.)
1. Unscrew both sides of the main body cover using the
driver supplied in this package.
2. See the following picture for main body with cover
detached. Hard disk connector is indicated in a red
ellipsoid in the picture below.
.
3. As shown below, tilt hard disk by 15 degrees and push
it forcefully into place. Hard disk pins have to fit into the
main body.
HDD
JUMPER PIN
4. Then, tighten the hard disk screw on two parts of the
hard disk marked in blue circles below(On the rear).
5. See the picture below for hard disk loaded properly.
6. Put the cover and tighten the cover screws supplied
in the package on eight parts as shown below in blue
circles(Four parts per side).
Caution:
When loading hard disk, be careful that static
electricity is not generated around the circuit.
Static electricity causes fatal damage to the circuit.
Note:
For hard disk requiring much power supply, PC
cannot often recognize it when it has USB power
supply only. In this case, connect separate adapter
for home to RSH-250 to supply power.
