Rapid Electronics KG888, Installation Handbook

Page: 5 / 24

4
1. One chirp Turbo timer is on
2. Two chirps Turbo timer is off (Factory default)
REMOTE ENGINE START WARM-UP TIME:
This system has two options for start warm-up time - 6 or 18 minutes, which is
programmed by remote.
Turn on the ignition switch, press button
҇ʾ҉
ʳ
at the same time for over 2 seconds.
1. One chirp Remote engine start warm-up for 18 minutes
2. Two chirps Remote engine start warm-up for 6 minutes (Factory default)
POWER FAILURE MEMORY:
Any attempt to interrupt the power and connect it again, the alarm will keep the original
status.
REMOTE ENGINE STARTING:
Press button
Ζ
for engine start. The siren chirps once (If previous status is silent arming mode,
the siren no chirp). There are two modes for engine starting.
ϡ
Diesel engine mode:
Lights flash 7 times, the engine will start with 7-second pre-heating.
ϡ˚˴̆̂˿˼́˸ʳ˸́˺˼́˸ʳ
mode:
Lights flash 3 times and engine starts automatically.
1. If the car doesn’t start successfully, or engine stops, the system will start again up to 5
times.
2. After the engine is started, the lights will flash. After 20 seconds, the air regulator will
be activated.
3. Press button
Ζ
again to stop the engine and system will return to previous status.
4. Start the engine in arming mode:
ϡ
Press button
҈ʳ
to unlock the doors, the system will enter disarm mode directly.
ϡ
Any attempt to open the door or hood will trigger the alarm, the system will kill the
engine, flash the lights and sound for 60 seconds, then return to arming mode.
ˈˁ
After the engine has been started for 6/18 minutes, the system will kill the engine and
return to previous status and the siren will sound for 3 seconds.
ʳ
Note:
ʳ˜˹ʳ̇˻˸ʳ˶˴̅ʳ˼̆ʳ˼́ʳ˴˵́̂̅̀˴˿ʳ˶̂́˷˼̇˼̂́̆ʳʻ˼ˁ˸ˁʳ˛˴́˷ˀ˵̅˸˴˾ʳ˼̆ʳ́̂̇ʳ̃̈˿˿˸˷ʳ̈̃ʼʿʳ̇˻˸ʳ̆̌̆̇˸̀ʳ̊˼˿˿ʳ˸˶˻̂ʳ
̇̊̂ʳ˿̂́˺ʳ̆̂̈́˷̆ʿʳ˴́˷ʳ̅˸̇̈̅́ʳ̇̂ʳ̃̅˸̉˼̂̈̆ʳ̆̇˴̇̈̆ˁʳ
ʳ
LED STATUS INDICATOR
Slow flash
Fast flash
Steady light
No light : Arm / alarm / panic / anti-hijack.
: Auto re-arm.
: Last door arming / send message to controller.
: Disarming mode.
Note: Main unit will not accept the command during sending message to
controller.