Rapid Electronics KG888, Installation Handbook

Page: 2 / 24

1
FEATURES:
1. Code Hopping and Code Learning.
2. Remote Starting.
3. Remote (silent) arming/disarming.
4. Starter disable (500mA negative
output when armed)
5. Auto re-arm.
6. Driving lock mode.
7. Car (silent) searching.
8. Audible intrusion zone identification.
9. Defective zone alert and by-pass.
10. Power failure memory.
11. Key-less entry.
12. Remote panic.
13. Anti-hijack.
14. Emergency reset.
15. Last Door Arming set by transmitter.
16. When triggered by sensor, the siren
will sound for 30 sec. and reset
automatically.
17. When triggered by door, trunk, hood
or ACC the siren will sound for 60
seconds.
18. Built-in actuator’s relay.
19. Central locking, active time selectable– 0.5
or 3.5 seconds.
20. Two negatives and one positive trigger
input.
21. Plug-in dual zone shock sensor.
22. Pre-warn away.
23. Multi-function LED status indicator.
24. Inline fuse protection.
25. Remote trunk release (for optional trunk
opener system).
26. Windows close (for optional window closer
system).
27. Remote engine warm-up time (6 or 18
minutes.)
28. Programmable Gear Sensor.
29. Valet mode.
30. Turbo timer – 2 minutes.
ARMING:
When exiting the vehicle, press and release button
҇
(not over 2 seconds) siren will chirp
once to confirm arming. Lights flash once, doors lock, power windows roll-up (if installed)
and engine kill is enabled.
DISARMING:
In armed mode, press and release button
҈
, siren will chirp twice, lights flash twice, doors
will unlock and engine kill disables.
SILENT ARMING:
Press the button
҉
, the system will have no audible confirmation but lights will flash once.
AUTO RE-ARMING:
After disarming the alarm system, if the car owner does not enter the vehicle and turn on the
ignition switch within 30 seconds, then after 20 seconds the alarm will re-arm.
DEFECTIVE ZONE ALERT & BY-PASS:
While arming the alarm, if the siren chirps 4 times (3 times for silent arming), this means that
there is a door not shut properly. The alarm will bypass that zone, however, it will still
protect other zones.
ALARM MODE & WARN AWAY:
Pressing button
҇Ε҈ʳ ̂̅ʳ ҉ʳ
will stop alarm trigger mode, and system will remain in armed
mode.
1.
If the alarm is triggered by the first stage of the shock sensor, the siren will sound for 2
seconds.
2. If the car is tampered with or bumped into, the alarm will sound for 30 seconds and then
re-arm.
(In silent arm mode, the siren will not sound for being triggered by sensor)