JOG SPEED ADJUSTMENT & DANCER ARM
CALIBRATION
Your straightener was shipped with the dancer arm set up for it's
correct position so the only thing that has to be reset would be
the jog speed if you need your unit to jog faster or slower.
To reset the jog speed, turn off the main power switch. Press and
hold the "Run/Stop/Jog" button while turning the main power switch
on. The first screen you will see will display the jog speed percentage.
SETUP SENSOR
NEXT
To increase the jog speed, press the "Start Speed"
pushbutton. If you want to decrease the jog speed press the
"Start Speed" pushbutton.
%
SPEED
+
%
SPEED
The jog speed is shown in the percent of maximum jog speed.
Once you have set the desired jog speed push the "Run/Stop/Jog"
button once for next. Your jog speed is now set.
The next screen asks if you want to set up the sensor (commonly
referred to as "dancer arm calibration"). Use the percent speed
Select "no" if all you wanted to do was change the jog speed, select
"yes" if you want to calibrate the dancer arm by resetting the sensor.
buttons to select "yes" or "no".
YES
NO
After making your selection, press
"Run/Stop/Jog" for next.
If you selected "yes" the next screen asks you to set the low set point.
If the dancer arm is resting on the positive stop then just save this
setting by pushing the "Run/Stop/Jog" button.
JOG SPEED
NEXT
23% +
_
_
SENSOR LOW SETPOINT
SAVE
xxx
8
Summary of Contents for SA3
Page 6: ......
Page 15: ...13 RAPIDAIR 40 5 PASS LINE 20 28 SA3 SA3M CABINET ASSEMBLY ...