SAFETY, OPERATORS & MAINTENANCE MANUAL
GB-22
7
OPERATION
7.1 DAILY INSPECTION
1.
Perform a visual inspection of the entire unit, look for signs of wear, loose hardware and missing or
damaged components. Check for fuel and oil leaks to ensure connections are tight and hoses and
tubes are in good condition.
2.
Check the fuel supply, radiator coolant level, crankcase oil level and air cleaner is clean. All fluids
must be at the full mark with the engine cold.
3.
Make sure the cutting unit is adjusted correctly.
4.
Test the operator presence and safety interlock system.
THE DAILY INSPECTION SHOULD BE
PERFORMED ONLY WHEN THE ENGINE IS
OFF AND ALL FLUIDS ARE COLD. LOWER
IMPLEMENTS TO THE GROUND, ENGAGE
PARKING BRAKE, STOP ENGINE AND
REMOVE IGNITION KEY.
Summary of Contents for Mastiff 91
