en-72
8 MAINTENANCE AND LUBRICATION
8.1.2
FLAIL SERVICE ______________________________________________________
8.1.3 V-BELT ____________________________________________________________
The V-belt is tensioned by a counterweight. If the V-belt is not sufficiently tensioned, it must be re-tensioned. If
there are any tears or the V-belt is damaged, it must be replaced.
There is an inspection opening on the machine.
• Remove the screws, remove the safety cover.
• Check the V-belt for damage
• Reassemble the safety cover
FLAIL UNIT SERVICE INTERVAL CHART
Interval
Item
Section
First hour of
operation
Drive belt tension
Check all fasteners, replace all missing hardware
Visually inspect implement
-
-
-
Once Daily
Lubricate rotor and roller bearings
Check all fasteners, replace all missing hardware
Inspect hoses for any damage
Clean cutting units and visually inspect units and pivots for wear
Check all rotor fasteners, replace all missing hardware and cutters
-
-
-
-
-
After 50 hours
of operation
Check Flail Drive belt and adjust tension
Lubricate shafts and pins
-
-
Every 6 Years
Replace hydraulic hoses
-
Lubricate these fittings every week.
Lift arm Gimbal.
Front Pivot Arm.
Castor wheel mounting pivot.
Cutting Implement Rear roller
Flail rotor bearing housing.
The bearings and pivot points must be lubricated regularly with Shell Gadus S2 or equivalent.
Lubricate only with 1-2 strokes with the grease gun according to the maintenance chart or after
heavy use.
Inspection opening
Screws
Safety cover
Bolt
Bolt
