INSTALLATION
LOCATION
Control Panel
>
The PulseTrack 2 Control Panel
MUST
be located outside the hazardous area (see
NFPA-33).
>
This manual
MUST
be read and thor-
oughly understood by
ALL
personnel who
operate, clean, or maintain this equipment.
Special care should be taken to ensure that
the
WARNINGS
and requirements for oper-
ating and servicing safely, are followed.
W A R N I N G
!
Install the control panel in a convenient area
outside the hazardous location, where it will be
protected from the possibility of any contact with
water, vapor or high humidity, and ambient tem-
peratures do not exceed 120
°
F (49
°
C). The area
should be clean, dry and well ventilated.
Brake Valve(s)
(Bells Only - Optional)
If a bell system is ordered with the brake option
an A11547 Brake Valve Assembly will be supplied
for each bell. Install the brake valve assembly(s)
on the LA0042 Air Manifold Assembly (supplied
separately) as follows (see Figure 3):
1. Remove the turbine air volume booster from
the manifold by loosening the swivel fitting.
2. Attach the swivel fitting of the brake valve
assembly to the manifold fitting.
3. Attach the swivel fitting of the turbine air volume
booster to the brake valve fitting.
The LA0042 Air Manifold should be mounted in a
convenient location such that the maximum tubing
lengths from the control panel to the brake valve
and the brake valve to the rotator do not each
exceed 100 ft. (30.5m).
>
Do not locate the control panel near
or adjacent to heat producing equipment
such as ovens, high wattage lamps,
steam pipes, etc.
C A U T I O N
!
Bolts or screws used for mounting must be at
least 3/8" (9.5mm) in diameter. If mounting to a
non-metallic wall, the mounting screws must be
secured to studs in the wall. If mounting to a metal
wall, the wall must be at least 0.100" (2.5mm) thick.
Summary of Contents for Pulsetrack 2
