Ransburg 19372, Service Manual

Page: 12 / 64

AH-95-02.4
INST INST
INST INST
INSTALLA ALLA
ALLA ALLA
ALLATION TION
TION TION
TION
DO NOT DO NOT DO NOT DO NOT DO NOT use the power supply
ground wire to ground the target objects.
C A U T I O N C A U T I O N C A U T I O N C A U T I O N C A U T I O N
!!!!!
8 8
8 8
8
PRE-INST PRE-INST
PRE-INST PRE-INST
PRE-INSTALLA ALLA
ALLA ALLA
ALLATION TION
TION TION
TION
REQUIREMENTS REQUIREMENTS
REQUIREMENTS REQUIREMENTS REQUIREMENTS
1. Provide approved electrical wiring to the
power supply. See NFPA Bulletin No.
33, OSHA regulations, and your local
codes.
2. Make sure the operating location has ad-
equate grounding facilities, such as elec-
trical conduit, steel building columns,
metal water pipes, or other earth
grounded objects.
3. Furnish a paint pressure pot with air
regulator (or other accepted pressure
system). The regulator MUST have a
reliable control, with a recommended
gauge range of 0-30 psig (0-2.1 kg/cm
2
).
4. Provide proper ventilation. (See "Safety"
section of this manual.)
5. Ensure that the target object to be
coated and all surrounding objects are
grounded to a known, positive ground by
a separate ground wire attachment.
SAFEGUARDS SAFEGUARDS
SAFEGUARDS SAFEGUARDS
SAFEGUARDS
When operating this equipment in the vicinity of
computers, word processors, and/or other elec-
tronic equipment, special care MUST be taken
to ensure that damage does not occur from
electrical energy discharges. (See Ransburg
safety literature for further information regarding
application.)
The following guidelines can be used:
• It is highly recommended, whenever possible,
that ALL electronic components or equipment
be removed from the spray area. This in-
cludes computer software such as tapes,
disks, diskettes, etc., located inside and/or
around the spray area.
• If the static shielding of a unit is NOT
KNOWN, all electronic components (such as
terminals, screens, and cables) should be
completely wrapped in aluminum foil and
grounded to a true earth ground.
• When painting electrical control panels or con-
soles, wrap all push-buttons, switches,
meters, or pilot lights with aluminum foil and
ground to the panel or other earth ground.
EQUIPMENT EQUIPMENT
EQUIPMENT EQUIPMENT
EQUIPMENT
INST
INST
INST INST INSTALLA
ALLA
ALLA ALLA ALLATION
TION
TION TION TION
NEVER NEVER
NEVER NEVER
NEVER wrap the applicator, associated
valves and tubing, and supporting hardware
in plastic to keep it clean. A surface charge
may build up on the plastic surface and
discharge to the nearest grounded object.
Efficiency of the applicator will also be
reduced and damage or failure of the
applicator's components may occur.
WRAPPING THESE COMPONENTS
WRAPPING THESE COMPONENTS
WRAPPING THESE COMPONENTS WRAPPING THESE COMPONENTS WRAPPING THESE COMPONENTS
IN PLASTIC WILL VOID WARRANTY.
IN PLASTIC WILL VOID WARRANTY.
IN PLASTIC WILL VOID WARRANTY. IN PLASTIC WILL VOID WARRANTY.
IN PLASTIC WILL VOID WARRANTY.
W A R N I N G W A R N I N G
W A R N I N G W A R N I N G
W A R N I N G
!!!!!
Before attempting to install the equipment, en-
sure that all the necessary components are
available (see "Parts Identification" section of
this manual). In addition, read all the technical
and safety literature that is provided. If the lit-
erature is not available, contact your local
Ransburg Distributor where the equipment was
purchased.