Rankam TF21330 Series Assembly, Use And Care Manual Download Page 4

TF2133002-RG-00  ENG                                                          Page  4  of  17                                                                  20160608-Ver.1   

foot clearance form walls or rails.   

 

Before opening LP tank valve, check the coupling nut for tightness. When appliance is not in use , turn off 
control knob and LP tank valve.   

 

Never move appliance while in operation or still hot.   

 

If you notice grease or other hot material dripping from appliance onto valve, hose or regulator, turn off gas 
supply at once. Determine the cause, correct, clean and inspect valve, hose and regulator before continuing. 
Perform a leak test. 

 

The regulator may make a humming or whistling noise during operation. This will not affect safety or use of 
appliance.   

 

Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion, wear, cuts or 
leaks, the hose must be replaced prior to the appliance being put into operation.   

 

 

WARNING 

 

 

Never use a cooking vessel larger than 30 qts. Diameter greater than 11-3/4 inches and taller than 15-1/2 
inches. 

 

Never fill pot above upper fill line. Oil can splatter causing staining or 
discoloration to ground surface. 

 

Never place empty cooking vessel on the appliance while in 
operation. Use caution when placing anything in the cooking vessel 
while the appliance is in operation.   

 

Never move the appliance when in use. Allow the cooking vessel to 
cool before moving or storing.   

 

Never leave the appliance unattended. Keep children and pet away 
from the appliance at all times. 

 

This appliance is not intended for and should never be used as a 
heater.   

 

Never operate appliance with LP tanks out of correct position 
specified in assembly instructions. 

 

Always close LP tank valve and remove coupling nut before moving 
LP tank from specified operating position. 

 

Appliance shall not be used for commercial cooking. 

 

This appliance will be hot during and after use. Use insulated oven mitts or gloves for protection from hot 
surfaces or splatter from cooking liquids.   

 

Avoid bumping of or impact with the appliance to prevent spillage or splashing of hot cooking liquid. 

 

Never drop food or accessories into hot cooking liquid. Lower food and accessories slowly into the cooking 
liquid in order to prevent splashing or overflow. When removing food from the appliance care should be taken to 
avoid burns from hot cooking liquids.   

 

 

DANGER 

 

 

The safety relief valve on the LP tank could activate releasing gas and cause an intense fire with risk of death or 
serious injury. Therefore, follow instructions bulleted below exactly. 
(a)  Do not store a spare LP-gas cylinder under or near this appliance. 
(b)  Never fill the cylinder beyond 80 percent full; and 
(c) 

If the instructions in (a) and (b) are not followed exactly, a fire causing death or serious injury may occur.   

 

If you see, smell, or hear escaping gas, immediately get away from the LP tank/appliance and call your fire 
department. 

 

All spare LP tanks must have safety caps installed on the LP tank outlet.

 

 
 

LP Tank Removal, Transport and Storage 

 

Turn OFF all control knobs and LP tank valve. Turn coupling nut 
counterclockwise by hand only 

– do not use tools to disconnect. Place dust cap 

on cylinder valve outlet whenever the cylinder is not in use. Only install the type 
of dust cap on the cylinder valve outlet that is provided with the cylinder valve. 
Other types of caps or plugs may result in leakage of propane. 

 

A disconnected LP tank in storage or being transported must have a safety cap 
installed (as shown). Do not store an LP tank in enclosed spaces such as a 
carport, garage, porch, covered patio or other building. Never leave an LP tank 
inside a vehicle which may become overheated by the sun. 

Keep the fuel supply hose away 

from any heated surface 

 

Summary of Contents for TF21330 Series


















Reviews: