TF2133002-RG-00 ENG Page 12 of 17 20160608-Ver.1
2. Attach thermocouple (D) to
thermocouple bracket (E) which has
been fixed to the burner.
Attach thermocouple (D) as per
right drawing and tighten the nut
(Y).
3. Insert the burner through the
bottom of the stand (3), in between
wind shield (F) (side with rectangle
lip) and burner support bar (G).
4. Unscrew the pre-assembled nut from the
threaded pin of the burner (5). Align timer
control box (6) to the timer box support bar (4)
and fix it with 2 pieces M6x12 screws by going
through the support bar (4) and then to the time
box (6). Then align burner (5) base to burner
support bar (G). Align holes on heat shield (11)
with threaded pin and alignment pin of the
burner (5) through hole in burner support bar
(G), then through small hole of heat shield (11).
The alignment pin on bottom of burner (5) must
be inserted through the large hole of the heat
shield (11), Tighten hex nut onto bolt of the
burner (5). Finally, fix the support bar (4) to legs
of stand with 2 pieces M6x12 screw by going
through the holes on legs and then through the
holes of support bar (4). Tighten the screws
with 2 pieces M6 nuts.
