TF2005101-KK-00 English
11
081516Ver1
Assembly Instructions:
1. Attach burner (2) to automatic
shut off valve (A) in the timer
control box (3) by turning the
burner clockwise. Do not fully
tighten burner to the valve,
tighten until
3 threads
remain
visible on the valve. Attach
thermocouple (D) to
thermocouple bracket (E) which
has been fixed to the burner.
2. Attach thermocouple (D) as per right drawing and tighten the nut (Y).
3. Insert burner through the bottom of the stand (1), in between wind
shield (F) (side with rectangle lip) and burner support bar (G).
4. Unscrew the pre-assembled nut from the threaded pin of the burner
(2). Align timer control box (3) to the timer box support bar (1A) and
fix it with 2 pieces M6 x 12 bolts by going through the support bar
(1A) and then to the time box (3). Then align burner (2) base to
burner support bar (G). Align holes on heat shield (4) with threaded
pin and alignment pin of burner (2) through hole in burner support
bar (G), then through small hole of heat shield (4).
The alignment pin on bottom of burner (2) must be inserted through
the large hole of the heat shield (4), tighten hex nut onto bolt of
burner (2). Finally, fix the support bar (1A) to legs of stand with 2
pieces M6 x 12 bolts by going through the holes on legs and then
through the holes of support bar (1A). Tighten the bolts with 2 pieces
M6 nuts.
5. When transporting or storing LP cooker without tank attached, hook
regulator onto burner or cooker stand to prevent damage to
regulator.
6. Finally, unscrew the two screws from the lid handle by loosing the
nuts. Align the lid handle on the lid and fix it with two screws and
nuts again.
Proper connection is
critical for correct
operation of unit
A
