TF2005101-KK-00 English
4
081516Ver1
WARNING
Never use a cooking vessel larger than 30 qts. Diameter greater than 11-3/4 inches and taller than 15-1/2 inches.
Never fill pot above upper fill line. Oil can splatter causing staining or discoloration to ground surface.
Never place empty cooking vessel on the appliance while in operation. Use caution when placing anything in the
cooking vessel while the appliance is in operation.
Never move the appliance when in use. Allow the cooking vessel to cool
before moving or storing.
Never leave the appliance unattended. Keep children and pet away from
the appliance at all times.
This appliance is not intended for and should never be used as a heater.
Never operate appliance with LP tanks out of correct position specified in
assembly instructions.
Always close LP tank valve and remove coupling nut before moving
LP tank from specified operating position.
Appliance shall not be used for commercial cooking.
This appliance will be hot during and after use. Use insulated oven mitts or gloves for protection from hot surfaces
or splatter from cooking liquids.
Avoid bumping of or impact with the appliance to prevent spillage or splashing of hot cooking liquid.
Never drop food or accessories into hot cooking liquid. Lower food and accessories slowly into the cooking liquid in
order to prevent splashing or overflow. When removing food from the appliance care should be taken to avoid
burns from hot cooking liquids.
DANGER
The safety relief valve on the LP tank could activate releasing gas and cause an intense fire with risk of death or
serious injury. Therefore, follow instructions bulleted below exactly.
(a) Do not store a spare LP-gas cylinder under or near this appliance.
(b) Never fill the cylinder beyond 80 percent full; and
(c)
If the instructions in (a) and (b) are not followed exactly, a fire causing death or serious injury may occur.
If you see, smell, or hear escaping gas, immediately get away from the LP tank / appliance and call your fire
department.
All spare LP tanks must have safety caps installed on the LP tank outlet.
LP Tank Removal, Transport and Storage
Turn OFF all control knobs and LP tank valve. Turn coupling nut counterclockwise by hand only
– do not use tools to
disconnect. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust
cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in
leakage of propane.
A disconnected LP tank in storage or being transported must have a safety cap installed (as
shown). Do not store an LP tank in enclosed spaces such as a carport, garage, porch,
covered patio or other building. Never leave an LP tank inside a vehicle which may become
overheated by the sun.
Do not store LP tanks in an area where children play.
LP Tank
The LP tank used with your appliance must meet the following requirements:
Purchase LP tanks only with these required measurements: 12
” (30.5cm) (diameter) x 18” (45.7cm) (tall) with 20lb.
(9kg). Capacity maximum.
The LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications for
LP-gas cylinders of the US Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339,
Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods.
LP tank valve must have:
Type 1 outlet compatible with regulator or appliance.
Safety relief valve.
UL listed Overfill Protection Device (OPD). This OPD safety feature is identified by a unique
triangular hand wheel. Use only tanks equipped with this type of valve.
LP tank must be arranged for vapor withdrawal and include collar to protect LP tank valve.
Keep the fuel supply hose away
from any heated surface
