TF2005101-KK-00 English
8
081516Ver1
7.
After burner is lit, continue to HOLD the push button
for 10 seconds and then release. Holding push
button of safety valve for less than 10 seconds will
cause burner flame to go out.
8.
If ignition does not occur in 5 seconds, turn the regulator and LP tank valve off, wait 5 minutes, and
repeat the lighting procedure.
9.
Check the position of thermocouple, make sure the
flame has full contact with the thermocouple.
Note: If thermocouple does not have full contact with
flame, unit will not stay lit.
10.
Cycle time for timer is around 15 minutes. If the timer is not reset within around 15 minutes, the burner
will shut OFF automatically. If this occurs, please follow lighting instructions and continue to cook.
CAUTION
If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF, wait 5 minutes, try again. If
the burner does not ignite with valve open OR if burner flame is accidentally extinguished after lighting, gas will
continue to flow out of the burner and could accidentally ignite with risk of injury.
Burner Flame Check
Light burner, rotate regulator knob from HIGH to LOW. You
should see a smaller flame in LOW position than seen on HIGH.
Always check flame prior to each use. The air damper (D)
mounted on the back of your burner helps to control the amount
of primary air that mixes with the LP gas. A blue flame with little
or no yellow flame provides the best heat. Adjust the air damper
by turning it clockwise or counterclockwise until the desired flame is achieved.
Turning LP Cooker Off
Turn all knobs to OFF position, Turn LP tank OFF by turning OPD hand wheel clockwise to a full stop.
Hose Check
Cleaning and inspection of pressure regulator and hose assembly prior to use.
Before each use, check to see if there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced prior to
the appliance being put into operation. The replacement hose assembly shall be that specified by the manufacturer.
Cleaning the Burner
CAUTION
Checking and cleaning burner / venture tubes for insect nests. A clogged tube can lead to fire beneath the appliances.
Spiders
‘nests or wasps’ mud inside the burner may cause fire at the air damper. If a fire occurs, immediately turn off
gas supply at LP tank valve.
HOLD the Push
button of safety
valve
