5
Subject to change without notice. Specifications without guarantee. / 08.01.2021
Connecting via TouchLink with a ZigBee remote control
1. Method 1:
Press the Prog. button 4 times in succession (or disconnect the unit from the mains 4 times). The connected strip
flashes 2 times. You have 180s for the further steps.
Method 2:
Disconnect the unit from the power supply and reconnect it. If the unit is not integrated in a ZigBee network, the
connection mode starts after 15s. 165s remain for the further steps. If the unit is integrated in a ZigBee network, the unit is in
connection mode immediately after plugging it in. 180s remain for the remaining steps.
2.
Bring the remote control / panel closer than 10cm to the LED power supply.
3.
Set the remote control / panel to TouchLink installation mode. Please refer to the
instructions of the respective control unit for this procedure.
4.
The control unit will display the successful
connection. In addition, the lamp connected to
the power supply unit lights up 2 times.
If the remote control and the receiver only communicate via TouchLink (not in a ZigBee network), a receiver can be connec-
ted to a maximum of one remote control. If the receiver and remote control are in a ZigBee network, a receiver can be
connected to a maximum of 30 remote controls.
When using Hue Bridge & Amazone Echo Plus, the remote control and the power supply must be registered in the network
before the TouchLink installation.
Connecting to a ZigBee Green Power remote control / panel
1.
Press the Prog. button 4 times in quick succession (or disconnect the unit from the mains 4 times in succession and
reconnect it). You have 180s to perform the following actions.
2
. Bring the Green Power remote
control / panel closer than 10cm to
the appliance
3
. The lamp connected to the unit will light
up twice to indicate that the operation was
successful.
Info: Each unit can be connected to a maximum of 20 ZigBee Green Power remote controls / panels.
