Ranger R980XR, Installation And Operation Manual

Page: 54 / 80

R980 Series of Tire Changers
54
P/N 5900158 — Rev. E1 — Nov. 2019
Troubleshooting
⚠
WARNING: Disconnect the Power Cord from power and the incoming from the Air Source
before performing any maintenance
. Take whatever steps are necessary to
make sure the unit cannot be re-energized while maintenance is being performed
on it (such as Lockout/Tagout). The unit uses pneumatic and electrical energy; if
your organization has Lockout/Tagout policies, make sure to implement them
before troubleshooting the Tire Changer.
Issue Action to Take
The Turntable does not move when
you step on the Turntable Foot
Pedal.
Make sure the unit is getting power.
The unit is not getting power. Have a licensed, certified Electrician check the electrical path
from the supplied cord to the power source. If any issues are
found, have them fixed. Refer to Wiring Information for
additional information.
No air comes out of the Air Hose
when you step on the Inflate Foot
Pedal.
Make sure the unit is correctly connected to a working Air
Source.
It is difficult to secure Tires when
clamping externally.
Use the Restraint Cone to press the Tire down so the Clamps
correctly grab the Rim of the Wheel.
The Inflation Gauge is not working
correctly.
Check the accuracy of the Inflation Gauge with a professional
gauge. Fix immediately if the Inflation Gauge is not working
correctly.
The Assist Arms (R980 only) move
up and down slowly or make odd
noises when moving.
Grease the Assist Tower Post, it has run out. Refer to
Grease the Assist Tower Post for more information.
If you continue to have problems with your Tire Changer, visit www.bendpak.com/support/ or call
BendPak Ranger at (805) 933-9970 .