R980 Series of Tire Changers
34
P/N 5900158 — Rev. E1 — Nov. 2019
Working with Custom and Special Wheels
This section covers working with Alloy Wheels with no drop center, European performance Wheels,
and Wheels with tire pressure monitoring systems.
Alloy Wheels
Some manufacturers offer Wheels with little or no drop center. These types of Wheels are almost never
Department of Transportation approved.
⚠
DANGER
The Tire, Wheel, or both can be damaged and the Tire could explode under
pressure, resulting in serious injury or death.
BendPak Ranger recommends
you not try to demount or mount this type of Wheel
. If you do attempt to
demount or mount this type of Wheel,
proceed with extreme caution
.
European Performance Wheels
Some European performance Wheels have very large humps except near the Valve Hole.
On these Wheels, the Beads should be loosened at the Valve Hole on both the upper and lower sides
first.
Wheels with Tire Pressure Monitoring Systems (TPMS)
Some Wheels have a pressure sensor located behind the Valve Stem. On these Wheels, the Beads
should be loosened opposite the Valve Stem on both upper and lower sides first, before breaking the
Beads on the rest of the Tire.
Performance Wheels on some Vehicles (including Corvette, BMW, and Lamborghini Diablo) have a
pressure sensor strapped to the rim opposite the Valve Hole. On these Wheels, the Beads should be
loosened at the Valve Hole on both the upper and lower sides first, before breaking the Beads on the
rest of the Tire.
Be mindful of the TPMS sensor when breaking a Tire’s Bead, demounting a Tire, and mounting a new
Tire. If your shop does not have specific recommendations for handling these situations, BendPak
Ranger recommends:
•
When breaking a Tire’s Bead
. Keep the TPMS sensor away from where the Bead is being
broken. Put the sensor at 12 o’clock high (relative to the ground) when breaking the Bead.
•
When demounting a Tire
. Put the TPMS sensor just to the right of the Mount/Demount Head.
•
When mounting a Tire
. Put the TPMS sensor just to the left of the Mount/Demount Head.
These are general guidelines; be sure to use common sense and take into consideration the specifics
of each situation.
When finished mounting a Tire with a TPMS sensor, check that it is working. It is against the law to
knowingly not re-install a working TPMS if the Vehicle arrived at the facility with a functioning TPMS. In
other words, if a Vehicle came in with a functioning TPMS, it needs to leave with a functioning TPMS.
Summary of Contents for R980XR
