EN
6
6
Mounting the hood body
• Before attaching the hood body, tighten the two screws
Vr
lo-
cated on the hood body mounting points.
• Hook the hood body onto the screws
12a
.
• Fully tighten the support screws
12a
.
• Adjust the screws
Vr
to level the hood body.
12a
Vr
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the
chimney using either a flexible or rigid pipe ø 150 or 125 mm,
the choice of which is left to the installer.
• To install a ø 125 mm air exhaust connection, insert the re-
ducer flange
9
on the hood body air outlet and the adapting
ring ø120-125
10
on the reducer flange.
• Fix the pipe in position using sufficient pipe clamps (not sup-
plied).
• Remove any activated charcoal filters.
9
ø 125
ø 150
10
RECIRCULATION VERSION AIR OUTLET
• Assemble the two halves of the hood body extension piece
14.
• Push fit the assembled hood body extension piece
14
onto the
air outlet.
• Push fit connection
15
onto the hood body extension piece
14.
• Insert the connection extension pieces laterally
14.1
in connec-
tion
15.
• Make sure that the outlet of the extension pieces
14.1
is hori-
zontally and vertically aligned with the chimney outlets. If this
is not the case, adjust the position by either reversing the con-
nection extension pieces
14.1
or by cutting the hood body ex-
tension
14
along one of the thinner section channels denoting
the pre-fixed lengths, then reassemble as described previously.
• The air outlet directional grills
8a - 8b
must be fitted after the
lower outlet duct has been installed.
• Ensure that the activated charcoal filters have been inserted.
14
14.1
15
8a
8b
Summary of Contents for RMHDT90SS
Page 1: ...RMHDT90SS RMHDT100SS RMHDT110SS Instructions Manual www rangemaster co uk...
Page 10: ......
Page 11: ......