Rane HC6S, Manual

Page: 18 / 24

Interconnection-6
Figure 4. Interconnect chart for locating correct cable assemblies on the following pages.
Note: (A) This configuration uses an “off-the-shelf” cable.
Note: (B) This configuration causes a 6 dB signal loss. Compensate by “turning the system up” 6 dB.
To Input
MALE
BALANCED XLR
¼" BALANCED
TRS (TIP-RING-SLEEVE)
¼" OR 3.5mm
UNBALANCED
TS (TIP-SLEEVE)
UNBALANCED RCA BALANCED
EUROBLOCK
From Output
1 2 3 4
6 5 2 1
10 9 8 7
12 11 8 7
12 11 22 21
16 23
23
15 14 13
20
24 24
19 18 17
B B
B B
A A
A A
A A
FEMALE BALANCED XLR
(NOT A TRANSFORMER,
NOR A CROSS-COUPLED
OUTPUT STAGE)
FEMALE BALANCED XLR
(EITHER A TRANSFORMER
OR A CROSS-COUPLED
OUTPUT STAGE)
¼” BALANCED TRS
(NOT A TRANSFORMER,
NOR A CROSS-COUPLED
OUTPUT STAGE)
¼” BALANCED TRS
(EITHER A TRANSFORMER
OR A CROSS-COUPLED
OUTPUT STAGE)
¼” FLOATING UNBALANCED
TRS (TIP-RING-SLEEVE)
(SLEEVE IN UNIT = NC)
¼” OR 3.5 mm
UNBALANCED
TS (TIP-SLEEVE)
UNBALANCED RCA
(TIP-SLEEVE)
CABLE
CONNECTORS
BALANCED
EUROBLOCK
+
to
+
–
to
–
SHIELD ONLY
TO XLR PIN 1
+
to
+
–
to
–
SHIELD NC
+
to
+
–
to
–
SHIELD NC
+
to
+
–
to
–
SHIELD ONLY
TO EUROBLOCK
+
to
+
–
to
–
SHIELD NC
+
to
+
–
to
–
SHIELD ONLY
TO TRS SLEEVE
+
to
+
–
to
–
GROUND to GROUND
+
to
+
–
to
–
GROUND to GROUND