Rane Four, User Manual, Page: 13 / 38

13
7.
Channel FX Knob: Turn this knob to adjust the filter
applied to the deck. Turn the knob counterclockwise to
apply a low-pass filter. Turn the knob clockwise to apply
a high-pass filter. Set it to the center (“12:00”) position to
deactivate the filters.
8. Channel FX Select: Press these buttons to select the
desired software Channel FX: Filter, Filter Roll, Noise, or
Flanger.
•
Filter: Pre-fader. Can be a software or hardware
effect. When used as a hardware effect, it is only
available for line/phono sources.
•
Filter Roll: Pre-fader. Software effect.
•
Flanger: Pre-fader. Software effect.
•
Noise: Pre-fader. Software effect.
Notes:
Upon power-up, the FX BPM will default to 100 BPM.
When connected to Serato DJ, the software will send the BPM (from the FX
Unit) for only the assigned channel as dictated by the hardware FX Assign
buttons (per side).
Use the Tap button to manually tap in the tempo in order to obtain the BPM for
line input signals.
9. Quantize: Press to activate quantize mode in the software.
10. Channel Cue: Press this button to send the pre-fader signal to the
cue channel for monitoring. When engaged, the button will be lit. To
cue multiple channels, press the Cue buttons at the same time for
each channel.
11. Channel/Deck Fader: Move this fader to adjust the volume level of
the corresponding deck.
12. Crossfader: Move this crossfader to mix between the decks. The
crossfader is user-removable and supports the Innofader as a
drop-in replacement. The crossfader tension can be adjusted by
removing the fader plate and adjusting the set screw on the
crossfader carrier.
13. Main Level: Turn this knob to adjust the output volume of the program mix. The
meters next to this knob indicate the audio signal level of the program mix.
14. Booth/Zone Level: Turn this knob to adjust the output volume of the Booth/Zone
Outs.
15. Sample Volume: Turn to adjust the gain of the software sample player.
16. Sampler Assign to Channel 4: Press to route the sampler to channel 4. This will
allow the sampler to have all gain, EQ, and FX controls for that channel.
17. Mic 1 On/Off / Talkover: Press this button to turn Mic 1 on and off.
Press and hold Shift and press this button to use the “talkover”
feature, which automatically reduces the volume level of the main
mix when you speak into the microphone. Talkover settings can be
adjusted in the System menu.
18. Mic 1 Level: Turn to adjust the level of Mic input 1.
7
8
10
11
12
14
9
13
15
17