R&S ZNC3, User Manual

Page: 341 / 795

GUI Reference
R&S
®
ZNC
325 User Manual 1173.9557.02 ─ 13
Auto Config NRP-Zxx
Causes the analyzer to clear the lists of "Known Devices" and "Configured Devices" and
automatically configure all NRP-Zxx power meters detected at any of the USB ports as
Pmtr 1, Pmtr 2... No manual configuration is required.
Remote command:
​
SYSTem:
​
COMMunicate:
​
RDEVice:
​
PMETer<Pmtr>:
​
CONFigure:
​
AUTO[:
​
STATe]
​
4.6.10 External Power Meter Config (Dialog)
Allows to modify configuration of certain external power meters, i.e. settings that are
persistently stored on the power meter (and NOT on the R&S ZNC). This requires the
respective device to be online, i.e. connected, switched on and ready to be used.
Deembed Two-Port (All Channels)
Reads and modifies the state of the built-in S-parameter correction that is available on
certain R&S®NRP-Z power sensors. See Application Note
1GP70: Using S-Parameters
with R&S®NRP-Z Power Sensors for background information.
Remote command:
​
SYSTem:
​
COMMunicate:
​
RDEVice:
​
PMETer<Pmtr>:
​
SPCorrection[:
​
STATe]
​
4.6.11 System > Print
Prints the active setup (i.e. the contents of the active diagrams) to an external printer, to
a file or to the clipboard. The settings are identical with the "File > Print" settings; see
​
chapter 4.1.2, "File > Print" , on page 109.
4.6.12 Additional System Functions
The "System" menu also provides the "Preset", "Undo", and "Redo" functions. These
functions are not included in the "System" softtool panels; they are accessible via hard-
keys in the SYSTEM panel.
Preset
Performs a preset of all instrument settings or of the active recall set, depending on the
settings in the "Presets" tab of the "SYSTEM > SETUP > Setup > System Config" dialog.
See
​
chapter 4.6.2.1, "Presets" , on page 309.
System Settings