Command Reference
R&S
®
ZNC
586
User Manual 1173.9557.02 ─ 13
Suffix:
<Ch>
.
Channel number. This suffix is ignored; the sweep mode applies
to all channels in the active recall set.
Parameters:
<Order>
ALL | AUTO | NONE
AUTO - optimized display update: fast sweeps are performed in
alternated mode, slower sweeps in chopped mode
ALL - chopped sweep mode, complete all partial measurements
before proceeding to the next sweep point
NONE - alternated sweep mode on, reverse the order of partial
measurements and sweeps
*RST:
NONE
Example:
COUP NONE
Activate the alternated sweep mode.
TRIG:LINK 'PPO'
Set the triggered measurement sequence equal to one partial
measurement. Each trigger event starts one partial measurement
for all sweep points.
Manual operation:
See
6.3.14.8
[SENSe:]FREQuency...
The
[SENSe:]...
commands set frequency-related parameters, especially the mea-
surement and display ranges for the different sweep types. The frequency ranges for the
different instrument models are listed below; for more details refer to the data sheet.
Table 6-7: Frequency ranges of R&S ZNC analyzers
Frequency settings
R&S ZNC3
Start, Stop
9 kHz to 3.0 GHz
Center
>9 kHz to <3.0 GHz
Span
1 Hz to 2.999991 GHz
.................................................................................587
..........................................................................587
.............................................588
.....................................................................................588
....................................................................................588
..................................................................................588
......................................................................589
....................................................................................590
...................................................................................590
....................................................................................590
SCPI Command Reference