R&S SMW-K44, User Manual

Page: 70 / 455

Space Vehicle Configuration Satellite Navigation
70 User Manual 1178.6379.02 ─ 01
Nav Msg Content, Config ← SV signal configuration table
Opens the "Navigation Message" dialog, where you can observe the navigation mes-
sage parameter and if enabled, change them.
See Chapter 12, "Perturbations and Errors Simulation" , on page 101.
Meander Sequence ← SV signal configuration table
Enables meandering, i.e. doubling the data rate of a GLONASS satellite navigation sig-
nal.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L1Band:CA:DATA:
MEANdering[:STATe]
on page 271
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L2Band:CA:DATA:
MEANdering[:STATe]
on page 271
Time Sequence ← SV signal configuration table
Enables the time signal component of GLONASS signals.
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L1Band:CA:DATA:
TSEQuence[:STATe]
on page 271
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GLONass:SIGNal:L2Band:CA:DATA:
TSEQuence[:STATe]
on page 271
Copy Modulation Control Settings to,SV-ID
Applies the power settings of the current satellite to the selected or to all SV-IDs of the
same GNSS system.
The following settings are considered:
●
Signal State
●
Primary Code
●
Seconadry Code
●
Nav Msg Control
●
Nav Msg Type, Pattern, Data List
●
Meander Sequence
●
Time Sequence
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MCONtrol:COPY:SVID
on page 271
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:MCONtrol:COPY:EXECute
on page 272
(etc. for the other GNSS systems)
9.3 Simulated Orbit and Orbit Perturbation Settings
Access:
1. Select "GNSS > Simulation Configuration > Satellites".
Simulated Orbit and Orbit Perturbation Settings