Space Vehicle Configuration
Satellite Navigation
69
User Manual 1178.6379.02 ─ 01
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:SIGNal:L1Band:E1OS:DATA:
SCODe[:STATe]
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GALileo:SIGNal:L1Band:E1OS:PILot:
SCODe[:STATe]
(etc. for the other GNSS systems)
Nav Msg Control ← SV signal configuration table
Defines whether the navigation message parameters can be changed or not.
"On/Edit"
Enables configuration of the navigation message parameters.
Navigation message content of the SBAS SV is set automatically. To
enable the navigation message for configuration, set "Satellites" >
= "Replay Historical Data (and Sync Atmos-
phere& SV Errors)".
If "Satellites" >
= "Replay Historical Data and
Sync Atmosphere& SV Errors", the navigation message content of all
other GNSS systems than SBAS is configured automatically. Editing
is not possible.
"Off"
Navigation message is disabled.
"Auto"
In
= "Navigation", the navigation message parameters are
adjusted automatically.
Remote command:
"Test Mode = Navigation"
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:CA:DATA:
NMESsage:CONTrol
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:P:DATA:
NMESsage:CONTrol
"Test Mode = Tracking"
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:CA:DATA:
NMESsage[:STATe]
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:P:DATA:
NMESsage[:STATe]
(etc. for the other GNSS systems)
Nav Msg Type, Pattern, Data List ← SV signal configuration table
Sets the data source used for the generation of the navigation message.
"LNAV/CNAV/INAV/DNAV/NAV"
The navigation message parameters are "real" since they are
retrieved from the loaded simulation data source file, see
.
To change the automatically filled in values, select:
●
= "Edit"
●
Remote command:
[:SOURce<hw>]:BB:GNSS:SVID<ch>:GPS:SIGNal:L1Band:CA:DATA:
NMESsage:TYPE
(etc. for the other GNSS systems)
Modulation Control Settings