R&S SMCVB-K164, User Manual

Page: 109 / 152

Remote-Control Commands
R&S
®
SMCVB-K164
109 User Manual 1179.0974.02 ─ 02
[:SOURce<hw>]:BB:T2DVb:PILot <PilotPattern>
Sets the pilot pattern.
Parameters:
<PilotPattern> PP1 | PP2 | PP3 | PP4 | PP5 | PP6 | PP7 | PP8
*RST:
PP7
Example: See Example "Configuring OFDM parameters" on page 106.
Manual operation: See "Pilot Pattern" on page 41
[:SOURce<hw>]:BB:T2DVb:USED[:BANDwidth]?
Queries the used channel bandwidth.
The used bandwidth depends on the channel bandwidth, the FFT size and the carrier
mode as described in
Table 4-2 .
Return values:
<UsedBW> integer
Range:
0.0 to 9999999.9
Example: See Example "Configuring OFDM parameters" on page 106.
Usage: Query only
Manual operation: See "Used Bandwidth" on page 40
6.6 System Commands
The section contains the commands for configuring the DVB-T2 system.
● Network Commands ..............................................................................................109
● L1 Commands ....................................................................................................... 114
● ID Commands ....................................................................................................... 118
6.6.1 Network Commands
Example: Configuring network parameters
********************************************************************************
// Configure multi-frequency network properties.
********************************************************************************
:SOURce1:BB:T2DVb:INPut:T2MI:INTerface 0
:SOURce1:BB:T2DVb:NETWorkmode MFN
:SOURce1:BB:T2DVb:TXSYs MISO
// Sets for multi input single output (MISO) transmission system.
:SOURce1:BB:T2DVb:MISO:MODE?
System Commands