R&S NRX-B4, User Manual

Page: 210 / 450

Remote Control Commands
R&S
®
NRX
210 User Manual 1178.5566.02 ─ 05
HIGH
~
10 k
Ω
LOW
50 k
Ω
*RST: HIGH
Manual operation: See "Trigger 2 Input Impedance" on page 60
TRIGger<undef>:ALL:HOLDoff <holdoff>
TRIGger<Measurement>[:CHANnel<Channel>]:HOLDoff <holdoff>
Sets the hold-off time, see Chapter 7.3.4, "Hold-Off Time" , on page 56.
The command is not fully R&S NRP2 compatible. If port 1 is assigned to measure-
ment 1 and so on, the command works. If port 1 is assigned to measurement 2, for
example, enable the R&S NRP2 emulation using
SYSTem:LANGuage "NRP2"
.
Suffix:
<Measurement>
.
1 to 4
Measurement channel
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Parameters:
<holdoff> Range: 0.0 to 10.0
*RST: 0.0
Default unit: s
Manual operation: See "Holdoff" on page 58
TRIGger<undef>:ALL:HYSTeresis <hysteresis>
TRIGger<Measurement>[:CHANnel<Channel>]:HYSTeresis <hysteresis>
Sets the hysteresis. A trigger event occurs, if the trigger level:
●
Falls below the set value on a rising slope.
●
Rises above the set value on a falling slope.
Thus, you can use this setting to eliminate the effects of noise in the signal for the edge
detector of the trigger system.
The command is not fully R&S NRP2 compatible. If port 1 is assigned to measure-
ment 1 and so on, the command works. If port 1 is assigned to measurement 2, for
example, enable the R&S NRP2 emulation using
SYSTem:LANGuage "NRP2"
.
Suffix:
<Measurement>
.
1 to 4
Measurement channel
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Measurement Settings and Results