R&S NRX-B4, User Manual

Page: 60 / 450

Configuration for All Measurement Types
R&S
®
NRX
60 User Manual 1178.5566.02 ─ 05
Trigger 2 Input Impedance ← Specific Trigger
Requires a power sensor with a trigger input.
Sets the termination resistance of the external trigger signal that is supplied at the trig-
ger input/output of the power sensor. Choose a setting that fits the impedance of the
trigger source to minimize reflections on the trigger signals.
Remote command:
TRIGger<Measurement>[:CHANnel<Channel>]:EXTernal<Port>:IMPedance
on page 209
7.4 Measurement Settings Dialog
Access: In the main measurement dialog, tap the displayed measurement value or
graphic . See also "Layout of the main measurement dialog" on page 31.
In this dialog, you select the measurement type and the channel calculation function.
Based on the selected measurement and function, you can assign one or two sensors.
The assigned sensors are called primary sensor and secondary sensor.
The functions described here apply to the continuous average, burst average, trace,
pulse analysis, time gate, timeslot. For the other measurements, see:
●
Statistics: Chapter 8.7.3, "Measurement Settings Dialog" , on page 93
●
NRT: Chapter 8.8.3, "Measurement Main Configuration Dialog" , on page 103
For configuring the assigned power sensors, see:
●
Quick Setup
●
Chapter 9, "Sensor Configuration" , on page 104
Figure 7-3: Example: continuous average
Measurement Settings Dialog