R&S FSW-K7, User Manual

Page: 64 / 407

Configuration
R&S
®
FSW-K7
64 User Manual 1173.9240.02 ─ 23
Remote command:
[SENSe:]CORRection:CVL:SELect
on page 202
Comment
An optional comment that describes the conversion loss table. The comment is user-
definable.
Remote command:
[SENSe:]CORRection:CVL:COMMent
on page 200
Band
The waveguide or user-defined band to which the table applies. This setting is checked
against the current mixer setting before the table can be assigned to the range.
For a definition of the frequency range for the pre-defined bands, see table 11-3 on
page 196 .
Remote command:
[SENSe:]CORRection:CVL:BAND
on page 199
Harmonic Order
The harmonic order of the range to which the table applies. This setting is checked
against the current mixer setting before the table can be assigned to the range.
Remote command:
[SENSe:]CORRection:CVL:HARMonic
on page 201
Bias
The bias current which is required to set the mixer to its optimum operating point. It
corresponds to the short-circuit current. The bias current can range from -10
mA to
10 mA. The actual bias current is lower because of the forward voltage of the mixer
diode(s).
Tip: You can also define the bias interactively while a preview of the trace with the
changed setting is displayed, see "Bias Settings" on page 60.
Remote command:
[SENSe:]CORRection:CVL:BIAS
on page 199
Mixer Name
Specifies the name of the external mixer to which the table applies. This setting is
checked against the current mixer setting before the table can be assigned to the
range.
Remote command:
[SENSe:]CORRection:CVL:MIXer
on page 201
Mixer S/N
Specifies the serial number of the external mixer to which the table applies.
The specified number is checked against the currently connected mixer number before
the table can be assigned to the range.
Remote command:
[SENSe:]CORRection:CVL:SNUMber
on page 202
Input and Frontend Settings