Configuration of EMI Automotive Band Evaluation Test
01.00
Rohde & Schwarz
EMI Automotive Band Evaluation with R&S©EMC32-K51
– 1SP07-
13
Table 2-1: General Settings
Receiver Check
If untagged the Receiver Settings will be checked during
Loading of the Template. This improves the loading speed
but reduces the security.
Device Mode
Here the operating mode of the selected measurement
device "Test Receiver" or "Spectrum Analyzer" is chosen:
Scan Mode:
In all sub-ranges the receiver is in Test
Receiver Mode
Sweep Mode:
In all sub-ranges the receiver is in Spectrum
Analyzer Mode
This is a customer specific mode,
which expects additional requirements
(customer specific
devices and / or actions referencing the frequency list) In
this mode the frequency steps are not defined by the
receiver device (like a scan mode) but by an additional
frequency list, that is not referenced in the template itself.
One measurement value will be done for every frequency of
the frequency list. In the case there is no frequency list
given this mode works like Scan Mode.
The next tab allows some setting for the report.
Figure 14: Report settings
Detailed setting like configuration of content and design are possible in the report
generator, which is described later.
Table 2-2: Report settings
EUT Information
An EUT Information file can be referenced and so included
into the Report.
Visible Columns in
the Report
The drop down list allows to select and de-select columns
of the result tables in the report. Only checked columns will
be shown.
Report Settings
A click on this icon pops up the standard setting for reports