Page
9
of
25
LP0289BK
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 33
PICTURE 34
FITTING INSTRUCTIONS
•
Remove the panniers, rider and pillion seats.
•
Remove the two bolts arrowed in
picture 1
.
•
Remove the two bolts arrowed in
pictures 2 and 3
, the remove both pannier mounting
brackets.
•
Remove the four bolts arrowed in
pictures 4 and 5
.
•
Carefully remove the rear sub-frame cowl.
•
Disconnect the three wiring plug sockets arrowed in
picture 6
.
•
Remove the four bolts arrowed in
picture 7
.
•
Remove the two bolts arrowed in
picture 8
.
•
Gently unclip the plastic under-tray from the location tabs shown in
pictures 9 and 10
and
gently lower the under-tray (you will have to feed the tool kit bungee through the slot in the
rear sub-frame) until it rests on the rear wheel.
•
With the under-tray lowered remove the two screws arrowed in
picture 11
.
•
Carefully remove the wiring taking note of its routing.
•
Carefully remove the original licence plate bracket while feeding all the wires through the
holes in the under-tray.
If reusing the original indicators
•
Remove the two bolts arrowed in
picture 12
and remove the licence plate bolt bracket.
•
Remove the nut arrowed in
picture 13
and remove the reflector.
•
Remove the three bolts arrowed in
picture 14
, the bracket can now be carefully separated
into two halves.
•
Remove the screw arrowed in
picture 15
and then the clamp plate and the spreader plate.
•
Then squeeze the rubber indicator stem to allow the indicator to be removed as shown in
picture 16
.
•
Repeat the above to remove the other indicator (please note the relevant sides as they have
drain holes which should point downwards on assembly).
•
Fit the indicators to the indicator/licence plate mounting bracket (
item 1
) as shown in
pictures 17, 18, 19 and 20
in the same manner as they were mounted originally (ensure
they are fitted on the correct sides).
