LP0245
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
7
Page | 7
FITTING INSTRUCTIONS
•
To fit the R&G tail tidy, first remove the seat using the key as shown in picture 1.
•
Remove the two ‘R’ clips indicated in picture 2 and remove the two pins indicated in picture
3.
•
Remove the under-seat tray cover as shown in picture 4.
•
Slide the rubber plug socket cover along the wiring loom to give access to the indicator and
licence plate illuminator as indicated in picture 5.
•
Disconnect the three plug sockets as arrowed in picture 6 (indicators and licence plate
illuminator).
•
Remove the four bolts arrowed in picture 7, while supporting the original licence plate bracket
from underneath.
•
Carefully lower the original licence plate bracket while feeding the wiring through the hole in
the under-tray.
If reusing the original indicators
•
Remove the screw arrowed in picture 8.
•
Remove the indicator clamp bracket as shown in picture 9.
•
Remove the indicator spreader plate as shown in picture 10.
•
Gently squeeze the indicator stem and remove the indicator
•
Repeat the above steps to remove the opposite indicator.
•
Fit the indicators into the new licence plate bracket (item 1) and secure as shown in pictures
11,12,13, and 14.
If using the mini indicators
•
To fit the R&G Mini Indicators (R&G mini indicator product code RG370 for bulb type
and RG371 for LED type or RG372 for Aero Style led type).
•
Position the two indicator adaptors (item 6 –I0039) onto the wiring of each indicator,
ensuring the sides facing each other have the raised centre profile, before fitting the
flanged nut supplied, as shown in pictures 15 and 16.
•
Feed the indicator wiring through the nut/wire cover (item 7) as shown in pictures 16 and
17 (it helps if a small amount of liquid detergent is used) and position the nut cover over
the nut.
•
Fit one length of heat-shrink (item 10) to the wires of each indicator.
•
Fit the R&G licence plate illuminator (item 9) as shown in pictures 18 and 19, please note
you will have to fit the light shroud and use a small amount of adhesive to hold it in
position. Fit one length of heat-shrink (item 10) to the wire. It is a good idea to reconnect
to the wiring loom using the supplied connector (item 13) to check at this stage (if
illumination fails, swap the bullet connections around).
•
Tidy the wiring to the licence plate bracket using the supplied clips and cable ties (items 5
and 12).
•
Offer the new licence plate bracket into position while feeding the wiring through the
hole in the under-tray as shown in pictures 20 and 21.
•
Fit the four button head bolts with washers (items 2 and 4) through the four holes in the
new licence plate bracket as shown in picture 22.
•
Secure using the four nuts with washers (items 3 and 4) as shown in picture 23, please
ensure the wires are not crushed.
