LP0197
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
4
Page | 4
PICTURE 9
PICTURE 10
PICTURE 11
PICTURE 12
FITTING INSTRUCTIONS
Remove the seat using the key.
Remove the four bolts that hold the seat lock mechanism (arrowed in picture 1) using
8mm socket and a wrench.
Slide off the wires protective cover and disconnect all tail unit connectors (rear light, both
indicators and licence plate light connectors) as shown in picture 2. Please take note of
the routing and where each connector connects to.
Remove the four bolts arrowed in picture 3 and gently retract the OEM tail unit assembly
and its wiring away from the sub-frame. Please note to keep the tail unit supported while
the bolts are being undone.
On the OEM tail unit assembly, working from underneath, remove the seat lock/ cable
cover by removing the two plastic expanders (arrowed in picture 4) using a phillip
screwdriver. Slide the cover backwards to remove it completely.
Remove the cable tie that holds the wiring bundle and unclip the two clips holding the
indicator wires onto the OEM tail unit bracket (as arrowed in picture 5)
If using the original indicators
Remove the spreader/ location plate arrowed in picture 6.
Gently squeeze the indicator stem and remove the indicator together with its wires.
Insert the OEM Indicator adapter (Item 13) into the indicator stem as shown in picture 7.
A