R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
Page | 6
FITTING INSTRUCTIONS
Remove pillion seat using the key.
Remove the two button head bolts that hold the rider seat (Arrowed in picture 1) using a 5mm
Allen key.
Starting from the L/H rear panel, remove the three torx head bolts arrowed in picture 2 using a
suitable tool. Gently pull the panel off to the side and remove it completely (be aware not to
lose the rubber grommet attached to the panel). Repeat the procedure for the R/H rear panel.
Remove the three torx head bolts arrowed in picture 3 and the push pins located underneath on
the undertray (arrowed in picture 4). Push pins can be removed by simply pushing the centre
pin in using a suitable tool and pulling the whole body off. Remove the rear panel by sliding it
off backwards.
Disconnect the main tail unit connector,
not the rear light connector
.
Undo the four bolts arrowed in picture 5 using an 8mm socket and a ratchet, support the OEM
licence plate hanger while undoing the bolts. Gently remove the entire assembly and the
wiring. Discard the rubber gasket as it’s no longer required.
In order to remove the indicators and it’s wiring, the OEM licence plate hanger needs to be
dismantled. It can be done by:
1.
Remove the two button head bolts arrowed in picture 6 using a 3mm
Allen key.
2.
Remove the two clips located on both sides of the hanger (labelled A in
picture 6)
3.
Remove the button head bolt on each indicator using a 5mm Allen key
(Arrowed in picture 7). It is advisable to protect your indicators prior to
removal as they can easily get damaged.
4.
Remove the two round clips securing the reflector (labelled A in picture
8)
5.
Remove the three button head bolts arrowed in picture 8 using 10mm
socket, a ratchet and a 4mm Allen key.
6.
Split the OEM licence plate hanger in halves, make note of the indicator
wiring, unplug the wiring from the sub-harness and remove the
indicators. Please note that the sub-harness is required to use with the
R&G Tail tidy at later stage.
If using OEM indicators
Mount the OEM R/H indicator onto the R/H indicator bracket (Item 4) and secure with OEM
button head bolt removed earlier. Feed the wire through the lower hole of the indicator bracket
(as shown in picture 9).
Mount the R/H Indicator assembly onto the licence plate holder (Item 9). Align the slot on the
Indicator bracket with the two in-line threaded holes on the right hand side of the licence plate
holder (Item 9). Secure with two M6 x 6mm bolts (Item 6) as labelled A in picture 10. Feed
the wiring through the round centre hole on the licence plate holder (Item 9) (Arrowed in
picture 10). Repeat the procedure for L/H indicator.
If using mini indicators (R&G product code RG370)
Fit them to the cable cover/ Indicator bracket (Item 14) as shown in picture 11
Mount the cable cover/ indicator bracket assembly onto the licence plate holder (Item 9) as
shown in picture 12 and feed the wiring through the square hole and the centre round hole on
the licence plate holder (Item 9) (shown in picture 13).
Place two M6 x 6mm bolts (Item 6) on both sides of the cable cover/indicator bracket (Item
14) and leave the centre threaded hole unbolted for base cover fitment at later stage.
