FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Exposure to Radio Frequency Radiation.
The TND
™
760 device transmits and receives radio frequency (RF) energy through its internal
antennas. The TND
™
760 cellular antenna is located at the top of the left edge of the device.
The Wi-Fi antenna is located near the center of the bottom edge of the device. TND
™
760 is
designed to operate with internal antennas and has no provisions for external antennas.
The TND
™
760 has been designed, tested and manufactured to comply with the limits for
exposure to RF energy set by the FCC. The radiated output power of the TND
™
760 device is
below the FCC radio frequency exposure limits. The FCC has granted an Equipment Authorization
for this model device with all reported SAR levels evaluated as in compliance with the FCC RF
exposure guidelines. SAR information on this model device is on file with the FCC and can be
found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on
FCC ID: A4C 01001A
.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
IC Compliance Statement
This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
IC CAUtIoN
Intentional or unintentional changes or modifications to the equipment not expressly approved by Rand
McNally could void the user’s authority to operation the equipment.
IC AttEStAtIoN DE CoNFoRMIté
Ce dispositif est conforme à la norme FCC Partie 15 et aux norme(s) RSS permis-exempte(s) d’Industrie
Canada. L’opération est soumise aux deux conditions suivantes:
1. Ce dispositif ne peut pas provoquer d’interférence nocive et
2. Ce dispositif doit accepter toute interference reçue, y compris les interférences qui peuvent causer
un mauvais fonctionnement du dispositif.
AttENtIoN
Les changements ou modifications à l’équipement, que ce soient intentionnelles ou non, non
expressément approuvés par Rand McNally pourraient annuler l’autorisation de l’utilisateur à utiliser cet
équipement.
IC: 10199A-01001A
For Sales Information Please Contact
RoadTrucker Inc
(www.RoadTrucker.com)
8312 Sidbury Rd.
Wilmington, NC 28411
(800) 507-0482 / (910) 686-4281
