21
SECTION IV - OPERATION
TURNING THE SYSTEM ON/OFF
SHUTDOWN CYCLE
NOTICE
Make sure all HVEs and saliva ejectors are closed before turning the system off.
The Badger LF can be run continuously throughout the workday. Avoid wasting electricity by turning off if vacuum will
not be needed for an hour or more.
NOTE:
No high-voltage switching with the Badger LF.
NOTE:
No special skills are required by the operator to safely utilize this equipment. Contact the installing dealer or
Ramvac if the following pages do not adequately answer all questions.
Turn the unit OFF at the end of each day. When the unit is turned off, the power status light will blink for 90 seconds,
the tank will drain, and the vacuum pump will RESTART and run for a period of 10 minutes. After this time has elapsed,
the unit will automatically turn off. This cycle is utilized to prevent corrosion to the pump.
VACUUM LEVEL
SEPARATION TANK
NOTICE
IMPORTANT: Fluids in the separation tank are hazardous. The Badger's drain must be properly connected to the
facility's sewer plumbing.
The Badger LF contains an integrated separation tank that will collect fluids that are evacuated from the operatory
room. If the fluid rises to an excessive level within the tank, the Badger LF will disrupt vacuum for approximately 60
seconds in order for the tank to drain. After this drain time has elapsed, the unit will automatically restart and restore
the vacuum.
The vacuum level of the Badger LF is factory set at 7 inch Hg (when all HVEs
and SEs are closed). Do not increase vacuuum level above 12 inch Hg.
Illuminated Remote Control Panel
Non-Illuminated Remote Panel
E2 Start/Run & Shutdown
Pushbuttons
Use this switch to turn system on and
off.
If you have no remote switch.
If you want to turn the system
on or off from the equipment’s
location.
Use this switch to turn system on
and off from a remote location.
Non-illuminated switches
provide no indication for system
status.
Use this switch to turn system on and off
from a remote location.
Switch light is steady-on when
system is running without “Fault”.·
Switch light flashes if a “Fault” has
occurred.
