4
Operation of your kettle
1.To fill the kettle, remove it from the power base and open lid by
lifting lid handle, fill with the desired amount of water.
Alternatively, the kettle may be filled through the spout. And the
water level should not exceed max marks or sit below min max.
Too little water will result in the kettle switching off before the
water has boiled.
NOTE:
Do not fill the water over the maximum level, as water
may spill out of the spout when boiling. Ensure that the lid is
firmly in place before plugging the power outlet.
2.Insert the connector first into the power socket of the kettle,
then connect the cord plug to wall outlet. Connector must be
fully inserted to power socket.
3.Press down the switch, the indicator will light up. Then start to
boil the water, the kettle will switch off automatically once the
water has boiled.
NOTE
：
Ensure that switch is free of obstructions and the lid is
firmly closed
，
The kettle will not turn off if the switch is
constrained or if the lid is opening.
4.Unplug first and remove the connector.
Note: make sure the connector and power socket must be dried
before the appliance is used again.
5. Lift the kettle from the power base and then pour the water.
NOTE: operate carefully when pouring the water from your kettle
as boiling water may result in scald, besides, don’t open the lid
while the water in the kettle is hot.
6.The kettle will not re-boil until the switch is pressed down
again. The kettle may be stored on the power base when not in
use.
NOTE
：
Ensure power cord is taken down when kettle is not in
use.
