background image

know your Kenwood
stainless steel jug kettle

spout

lid

water gauge

on/off switch with neon

360˚ powerbase

cord storage

scale filter

to use your stainless
steel jug kettle

1 Fill it through the spout or lid. The

water level must be between 'Max'
and 200ml (1 cup).

Always use the filter and never
overfill - boiling water may splash
out.

Be economical: do not boil more

water than you need.

To improve the quality of your

drinks always use fresh water.

Empty the kettle after each use.

2 Check the lid is closed. 
3 Plug in and switch on. The neon

will come on.

4 Your kettle will boil and switch off

automatically. To re-boil, wait a
few seconds - the on/off switch
needs time to reset.

If you experience problems

with your kettle switching

on and off during use or

switching off before boiling,

check that the flat element

is free from scale - see

“descaling”. If descaling

does not solve the problem

contact Kenwood customer

care.

Your kettle is fitted with a scale

filter to hold back limescale
particles.

If you find drops of water under

your kettle, don’t worry - it is just
condensation.

boil-dry protection

If you switch on with too little
water, your kettle will cut out
automatically. Switch off and let it
cool down before re-filling.
When it has cooled down, the
switch will reset itself.

care and cleaning

Before cleaning, unplug your kettle
and let it cool down.

the outside and powerbase

Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the metal and plastic
surfaces.

the inside

Wipe with bicarbonate of soda on
a damp cloth. Rinse thoroughly.

Even though your kettle comes
with a scale filter, you still need to
clean the inside (and the filter)
regularly.

the scale filter

1 Open the lid.
2 Remove the scale filter by 

 

holding the tab and then lifting the
filter out.

3

either

rinse under the tap or use

a soft brush

or

when descaling your kettle,

drop the filter in too. Rinse
thoroughly.

4 To re-fit the filter, hold the tab 

.

Then slide the filter down into the
bracket until secure 

.

safety

Always use the filter and never
overfill - boiling water may splash
out.

Avoid contact with steam coming
out of the spout area when
pouring and out of the lid when
refilling.

Beware: the metal body of the
kettle will get hot during operation.

Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the
kettle down.

If you do not need so much cord,
shorten it by wrapping any excess
cord around the bracket on the
underside of the powerbase 

.

Always unplug your kettle

when not in use.

Never put the kettle, powerbase,
cord or plug in liquid.

Do not use if there is 

any

damage

to the kettle, powerbase, cord or
plug. Get it checked or repaired:
see ‘service’.

This kettle is not intended for use
by young children or infirm persons
without supervision.

Young children should be
supervised to ensure they do not
play with the appliance.

Caution:

Do not operate the

kettle on an inclined surface.

Only use the powerbase supplied
and keep it clean and dry.

Make sure the lid is secure before
switching the kettle on.

Warning:

Do not remove the lid

while the water is boiling.

Make sure the kettle is switched
off before lifting or pouring.

Remove the kettle from the base
before filling or pouring.

Never put the kettle near or on
cooker hot plates or gas burners.

This kettle is for boiling water only.

This kettle is for domestic use only.

Failure to observe these cautions
may result in damage to the kettle.

before plugging in

Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.

important - UK only

The wires in the cord are coloured
as follows:
Green and Yellow = Earth, Blue =
Neutral, Brown = Live.

The appliance must be protected
by a 13A approved (BS1362) fuse.

WARNING: THIS APPLIANCE

MUST BE EARTHED.

Note:

For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).

If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable pug is inadvertently
inserted into a 13A socket outlet.  

This kettle complies with European
Economic Community Directive
89/336/EEC.

before using for the first

time

Remove all packaging and any
labels.

Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.

 

Reviews: