Page 10
WES
3
Installation and Operations Manual V2.0 Ramtech Electronics Limited 2020
1. Initial CONNECT Setup
To activate the WES
3
CONNECT, hold down ‘A’ and press ‘B’ three
times in quick succession. All three LEDs will briefly illuminate and then
the amber LED will flash.
Initial setup of the CONNECT is through a series of on-screen options
such as Language, Inspection Delay and Pre-Alarm mode options.
Language Selection
Select language, available options are English, German, French,
Spanish, Italian and Swedish. Select using the arrows to the side of
the screen - the selected language will be highlighted. Confirm using
the ‘tick’ button. Language settings can be changed at any time via the
menus within the CONNECT unit.
Inspection Delay
The Inspection Delay setting allows an optional delay period between
triggering a call point and the site wide alarm being raised. This can
allow time for the incident to be validated on site, and a decision to be
made to either
i) confirm alarm is genuine, raise site wide alarm and
evacuate site, or
ii) confirm false activation, cancel the alarm and return to
normal (non-alarm) state.
Default setting is 0 minutes (ie no delay), but can be set in 1 minute
increments up to a maximum 10 minutes. A confirmation screen will
be displayed to validate the setting and prevent accidental activation.
Select using the arrows to the side of the screen.
A final screen will then appear confirming your selection, then use the
‘tick’ button to confirm.
Note that Inspection Delay can only be set during the initial
network setup process.
Once set, the Inspection Delay can only
be set or changed by turning off all networked units, which resets the
network. This will clear any existing unit numbering and other network
settings from the network.
b
Basic System Setup - CONNECT