Ramsey Winch 400, Operating, Service And Maintenance Manual, Page: 17 / 30

17
15. Press bearing (item #29)onto worm and into housing.
NOTE: Be sure that thick shoulder of bearings outer
race (side with manufacturer's name and part number)
is out, away from worm threads. Attach adapter (item #2)
to gear housing using six capscrews (item #36.). Tighten
cap screws to 12 ft. lbs. (16.1 Nm.)each. Insert key
(item #18)into keyway of worm shaft. Slide tapered end
of coup ling (item #1)over end of worm shaft.
Place motor shaft, with key in keyway, into coupling.
Secure motor (item #48) to adapter, using two capscrews
(item #37). Tighten capscrews to 39ft. lbs. (53 Nm.) each.
15a. Place thrust washers (item #54)and thrust
bearing {item #25)over end of worm (item
#21)and into housing. Attach adapter (item
#1)with gasket (item #41) to housing, us-
ing six (item #32)capscrews. Tighten cap-
screws to 12 ft. lbs. (16 Nm.)each. Insert
new seal (item #50) into adapter and care-
fully place motor shaft, with key in keyway,
through seal, so as not to damage seal.
Insert motor shaft into end of worm (item
#21). Secure motor (item #45) to coupling
using two (item #33)capscrews with lock-
washers (item #40). Tighten capscrews to
39ft. lbs. (53 Nm.)each.
16. Place winch with gear housing cover down on
work bench. Drum shaft should be in vertical
position. Set springs (items #53 4 #54) into
pockets of gear housing with drag brakes (item #9)
on top of disc (item #55) and springs. Slide drum
assembly (item #10)onto drum shaft with drum jaws
upward.