Ramsey Winch 400, Operating, Service And Maintenance Manual

Page: 13 / 30

13
DIS-ASSEMBLY
Refer to parts list and parts drawing pages for
actual item numbers and corresponding part numbers.
INSTRUCTIONS FOR OVERHAUL OF RAMSEY
400/H-400 SERIES LEVER STYLE WINCHES
1. Drain oil from gear housing by removing
(item #SO)plug from bottom of gear hous-
ing. Remove relief fi tting and reducer
(items #46 & #48) from top of gear housing.
Remove mounting angles from winch by
removing hardware shown.
3. Remove key (item #18) from worm shaft. Remove
bearing cap (item #5) and gasket (item #43) by un-
screwing six capscrews (item #33). Remove seal
(item #51) from bearing cap and press new seal into
place. Drag brake disc (item #9), spacer (item #55)
and springs (items #53 & #54) should be examined
and replaced if necessary.
2. Slide clutch housing (item 14) from end of
drum shaft. Reove setscrew, spring and
poppet ball (items #37, #52, and #29) from
jaw clutch (item #7). Slide jaw clutch from
end of drum shaft.
Remove two keys (item #20) from keyways.
Once keys have been removed, drum (item
#10) and drum spacer (item #25) can be
removed from drum shaft.