Ramsey Electronics PM10DC, Manual

Page: 10 / 40

PM10DC
y
10
•
Locate the part from one of the bags.
•
Use tweezers to pick up the part, grabbing it across the body of the part,
not the solder connections.
•
Place the part in the assembly location. Use one hand to hold the
tweezers and part in place.
•
Use the other hand to re-heat the solder dab to melt it to the component
connection.
•
Let the solder cool and let go with the tweezers. Inspect orientation and
make sure the part is square and oriented over the correct pads. Also
make sure a connection doesn’t overlap or short across adjacent pads
and the part is placed flat on the PC board.
•
Apply solder to the rest of the pads.
•
Apply a touch more solder to the initial pad if needed to make sure there is
a good solder joint.